[Asterisk-Users] Re: cisco 3620 setup (newbie cisco alert)

[Asterisk]

ok, I'm starting to get confused, you must be getting annoyed .. how do 
I add this voice-port ?

Also, if I want to use * to handle all of the SIP internal calls, and 
cisco to handle to inbound and outbound isdn-32 PRI calls, what "feature 
set" of the IOS should I need ? What hardware on the cisco 3620 should I 
need ? I've got a PRI-1CE1U and a WIC-1MFT-E1 and a two-port fast 
ethernet. I also have a 2610 to play with if required :)

Many thanks for your help. It is much appreciated. There is only so much 
a newbie can do without advice.

Julian.

barney wrote:

> I can`t see voice-port in your configuration. Something like this:
>
> !
> voice-port 1/0:15            ; voice-port 1/0:15, if your D channel is 
> Serial1/0:15
> input gain -6
> output attenuation 14
> echo-cancel coverage 32
> echo-cancel suppressor
> cptone SK
> description E1
> bearer-cap Speech
> !
>
> If you configure voice-port, try again to configure dial-peer (port 
> x/y:15 command) and if you have DSPs in you box, you must see 
> something like this:
>
> SIP-3640#show voice dsp
>
> DSP  DSP             DSPWARE CURR  BOOT                         PAK TX/RX
> TYPE NUM CH CODEC    VERSION STATE STATE   RST AI VOICEPORT TS ABORT  
> PACK COUNT
> ==== === == ======== ======= ===== ======= === == ========= == ===== 
> ============
> C549 000 00 {high}    3.4.56 IDLE  idle      0  0 2/0:15    01     0 0/16
>         01 {high}    3.4.56 IDLE  idle         0 2/0:15    17     0 0/0
> C549 001 00 {high}    3.4.56 IDLE  idle      0  0 2/0:15    02     0 0/16
>         01 {high}    3.4.56 IDLE  idle         0 2/0:15    18     0 0/0
> ....
>
> If you don`t have any DSP in your C3620, it will be unusable. So check 
> it!
>
> -b
>