[Asterisk-Users] Re: cisco 3620 setup (newbie cisco alert)

[barney]

I think, that In C3600 platform, there is no  0:D port, but D channel is 
named as 0:15.
So try port 0/0:15, if you want to use first E1 port in first slot of 
router.

Anyway, try to use "?" character. Look:

SIP-3640(config-dial-peer)#port ?
  <2-3>  Voice interface slot #

SIP-3640(config-dial-peer)#port 2?
/

SIP-3640(config-dial-peer)#port 2/?
  <0-0>  Controller unit number

SIP-3640(config-dial-peer)#port 2/0?
:

SIP-3640(config-dial-peer)#port 2/0:?
  <15-15>  Controller ds0-group number

SIP-3640(config-dial-peer)#port 2/0:15

-b


----- Original Message ----- 
From: "Asterisk" <asterisk at dotr.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" 
<asterisk-users at lists.digium.com>
Sent: Tuesday, May 17, 2005 11:06 AM
Subject: [Asterisk-Users] Re: cisco 3620 setup (newbie cisco alert)


> kurt x wrote:
>
>>Since the 3620 has two slots it should be configured as follows:
>>
>>port <slot #>/0:D
>>
> This gives me:
>
> delta(config-dial-peer)#port 0/0:D
>                                   ^
> % Invalid input detected at '^' marker.
>
> delta(config-dial-peer)#
>
>>Kurt
>>
>>
>>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>