[Asterisk-Users] X100P installed OK, after added TDM400P Asterisk would no longer start

[Angus Comber]

----- Original Message ----- 
From: "Ralf Schlatterbeck" <ralf at zoo.priv.at>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" 
<asterisk-users at lists.digium.com>
Sent: Sunday, June 05, 2005 6:22 AM
Subject: Re: [Asterisk-Users] X100P installed OK,after added TDM400P 
Asterisk would no longer start


> On Sat, Jun 04, 2005 at 11:20:47PM +0100, Angus Comber wrote:
>> This is what I have:
>>
>> # Span 1: WCTDM/0 "Wildcard TDM400P REV H Board 1"
>> fxoks=1
>> fxoks=2
>> fxoks=3
>> # channel 4, WCTDM, inactive.
>>
>> # Span 2: WCFXO/0 "Wildcard X101P Board 1"
>> fxsks=5
>>
>> # Global data
>>
>> loadzone = us
>> defaultzone = us
>>
>>
>> Which from your response appears correct.
>>
>> Could it have confused the cards?  If I swap them in the config might 
>> that
>> work?
> Depends on the order you load the drivers I think. So swapping them in
> the config will probably help, yes. The FXS modules would then be 5-7
> and the FXO 1...
>
> You really have two boards, one with 3 FXS modules and one with a single
> FXO module?

In the end I just removed the X100P board.  I want to buy a four port analog 
trunk card and use this for real anyway.  I suspect however that if I had 
swapped the cards in the config it might have worked.

Angus

>
> Ralf
> -- 
> Ralf Schlatterbeck
> email: ralf at zoo.priv.at FAX: +43/2243/26465/23
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>