[Asterisk-Users] Need help configuring TDM10B / X100P Cards

[Mike Chapman]

Hi,

Would someone assist me with the configuration of my TMD10B and X100P cards? I would ask Digium but my support was good for only one install...( I had to rebuild my * box). I wrote down the configuration but I must have made a mistake somewhere.  I have followed the instructions on the Digium site but I must be missing something. Here's the config (snippets) I've been attempting to use:

/etc/zaptel.conf 
fxsks=1 # X100P
fxoks=2-5 the FXS(green) module is closest to the bracket if you are looking at the side of the card with all of the electronic components.
defaultzone=us
loadzone=us

/etc/asterisk/zapata.conf

echocancel=yes ; You can set this to 32, 64, or 128, tweak to your needs.
echocancelwhenbridged=yes
echotraining=400 ; Asterisk trains to the beginning of the call, number is in milliseconds
callerid=asreceived
signalling=fxs_ks group=1
context=incoming ; Points to the incoming context of your extensions.conf 
channel => 1

signalling=fxo_ks
callerid=
group=2
context=default
channel=> 2-5

When I run ztcfg -v I get an error message which says ZT_CHANCONFIG failed on channel 2: invalid argument. Did you forget that FXS interfaces are configured with FXO signalling and that FXO interfaces use FXS signalling?

What am I doing wrong?

Thanks,

Mike
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20050122/0ec54aef/attachment.htm