[Asterisk-Users] bri error

[David Masure]

Did you put your card in TE mode ?

To it seems you have configured your card to act like a NT but if you
are connected to bri telco lines, it should be in TE mode

check in your zaptel.conf : bri te signalling

regards

David



-----Message d'origine-----
De : Altus Snyman [mailto:altus at stormcorp.co.za]
Envoyé : vendredi 29 avril 2005 12:08
À : Asterisk Users Mailing List - Non-Commercial Discussion
Objet : [Asterisk-Users] bri error


Good day all
This is a error that keeps on popping up in my /var/log/messages when I
get incoming or outgoing calls on my bri card connected to 4 telco isdn
units?It is a junghanns 4 port card with the latest version of the
drivers and latest asterisk
Apr 29 11:37:39 ccv kernel: qozap: BAD CRC for hdlc frame on card 1
(cardID 0) S/T port 1
Apr 29 11:37:39 ccv kernel: qozap: check the 100 Ohm termination for
this span!
Apr 29 11:45:25 ccv kernel: zaptel Disabled echo canceller because of
tone (rx) on channel 1

Please help and advice?

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users