[Asterisk-Users] Installed ztdummy, Asterisk doesnt work anymore

[Michel Bachofen]

Hi

Since Im using the mISDN drivers and no zaptel stuff, I had to install 
ztdummy to get MeetMe to work. Well, that was the plan. Now, after getting 
the latest zaptel version over CVS (Im using Kernel 2.6), uncommenting all 
the modules except ztdummy in zaptel.sysconfig file and compiling this by 
"make", "make install" and "make linux26", I rebooted and recompiled 
Asterisk with "make install" again. Before all this, Asterisk worked 
perfectly fine, incoming and outgoing connections worked, everything did 
its job (except the MeetMe of course). But now I get the following errors 
when starting up Asterisk:

[ Booting.....................Apr 19 11:07:28 WARNING[6237]: 
chan_zap.c:9615 setup_zap: Ignoring switchtype
Apr 19 11:07:28 WARNING[6237]: chan_zap.c:9615 setup_zap: Ignoring pridialplan
Apr 19 11:07:28 WARNING[6237]: chan_zap.c:9615 setup_zap: Ignoring overlapdial
Apr 19 11:07:28 ERROR[6237]: chan_zap.c:9436 setup_zap: Unknown signalling 
method 'bri_cpe_ptmp'
Apr 19 11:07:28 WARNING[6237]: chan_zap.c:9615 setup_zap: Ignoring overlapdial
Apr 19 11:07:28 ERROR[6237]: chan_zap.c:9078 setup_zap: Signalling must be 
specified before any channels are.
Apr 19 11:07:28 WARNING[6237]: loader.c:345 ast_load_resource: chan_zap.so: 
load_module failed, returning -1
Apr 19 11:07:28 WARNING[6237]: loader.c:440 load_modules: Loading module 
chan_zap.so failed!

Now, I havent done anything to the zaptel.conf yet, Im not sure if I even 
have to (didnt have that file before all this)?

Looking forward to hearing anything in this matter :-(

Michel