[Asterisk-Users] T100P to Verizon Smart Jack Question

[Jon Bebeau]

The problem with the (not-so) Smart Jack is that they fail regularly.  I
have had so many problems caused by the Smart Jacks, that I don't use them
anymore - just plug into the can.  And, no green Digium light until you load
the software.

Jon

----- Original Message ----- 
From: "Steven Critchfield" <critch at basesys.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<asterisk-users at lists.digium.com>
Sent: Monday, October 11, 2004 2:02 PM
Subject: Re: [Asterisk-Users] T100P to Verizon Smart Jack Question


> On Mon, 2004-10-11 at 11:45 -0400, Cirelle Enterprises wrote:
> > Has anybody had any experience connecting the t100p to
> > a verizon smart jack.
> >
> > I've been told the t100p uses an RJ48 but not the revision
> > (i.e. C, S, X )
> >
> > I've created wires (RJ48C x-over) but no green light on the t100p
>
> > i've created wire (RJ48S)  no green light
> > (only because the HyperEdge Smart Jack says this is default
> > but can't confirm this to be true in my case).
>
> > Standard RJ45 ether cable gets ligts on the card and smart jack
> > but no signal
>
> Then you should have noticed then that no cross over cable is necessary
> to a smart jack. Only time to use a cross over cable is when connecting
> 2 end devices together.
>
> > zttool indicates OK for both the t100p and the tdm04b cards (no alarms)
> > I can ping the t100p but no further with the standard ether cable
>
> Are you doing data or voice on the T100P?
> -- 
> Steven Critchfield <critch at basesys.com>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>