[Asterisk-Users] 7960 utilize all lines
Jan Baggen
jbaggen at ip2.nl
Tue Nov 30 03:07:13 MST 2004
I have 2610 XM with 1 Fastethernet and VIC2-2BRI. Dialin and dialout over
pots is ok. Also inbound pots calls get redirected to Asterisk y.y.y.y
So far so good.
But I want to setup VOIP sessions with local carrier. I added dial-peer
40 for this. Session target x.x.x.x But calls will always get routed to
the pstn peers 50 and 60. Peer x.x.x.x is never contacted or tried.
My situation:
PSTN -> CISCO -> ASTERISK OK
ASTERISK -> CISCO -> PSTN OK
ASTERISK -> CISCO -> VOIP NOT OK (only needs outbound calls)
SIP01#sh dial-peer voice summary
dial-peer hunt 0
TAG TYPE MIN OPER PREFIX DEST-PATTERN FER THRU SESS-TARGET STAT
PORT
10 pots up up 0 down 1/0/0
20 pots up up 0 down 1/0/1
30 voip up up 2012345.. 0 syst
ipv4:y.y.y.y:5060
40 voip up up .+ 0 syst
ipv4:x.x.x.x:5060
50 pots up up .+ 5 up 1/0/0
60 pots up up .+ 5 up 1/0/1
dial-peer voice 10 pots
description INBOUND CALLS PSTN BRI0
incoming called-number 2012345..
no digit-strip
direct-inward-dial
port 1/0/0
!
dial-peer voice 20 pots
description INBOUND CALLS PSTN BRI1
incoming called-number 2012345..
no digit-strip
direct-inward-dial
port 1/0/1
!
dial-peer voice 30 voip
description INBOUND CALLS VOIP ASTERISK
destination-pattern 2051860..
session protocol sipv2
session target ipv4:y.y.y.y:5060
session transport udp
dtmf-relay sip-notify
codec g711alaw
no vad
!
dial-peer voice 40 voip
description OUTBOUND CALLS VOIP CARRIER
destination-pattern .+
session protocol sipv2
session target ipv4:x.x.x.x:5060
session transport tcp
dtmf-relay sip-notify
codec g711alaw
no vad
!
dial-peer voice 50 pots
tone ringback alert-no-PI
description OUTBOUND CALLS PSTN BRI0
preference 5
destination-pattern .+
no digit-strip
port 1/0/0
!
dial-peer voice 60 pots
tone ringback alert-no-PI
description OUTBOUND CALLS PSTN BRI1
preference 5
destination-pattern .+
no digit-strip
port 1/0/1
More information about the asterisk-users
mailing list