[Asterisk-Users] Cisco FXO Caller-ID

[Todd Weiser]

When caller-id enabled on voice port 2/3 system plays a congestion tone on answer (call never makes it to the Asterisk server), when caller-id is disabled, everything works fine. System is a Cisco 1760 running 12.3(10) on a VIC2-4FXO.

dial-peer voice 2 voip 
description Route Calls to Asterisk 
destination-pattern 790 
session protocol sipv2 
session target sip-server 
dtmf-relay rtp-nte 
codec g711ulaw 
no vad 

sip-ua 
retry invite 3 
retry response 3 
retry bye 3 
retry cancel 3 
timers trying 1000 
sip-server ipv4:10.0.1.129 

voice-port 2/3 
no comfort-noise 
connection plar 790 
caller-id enable 

Debugging shows (when caller ID is enabled): 
htsp_pre_connect_disconnect, cdb = 821DB748 cause = 11 

Any help would be appreciated!