[Asterisk-Users] TDM11B auto configuration issue

Stephen Smith stephen at norith.com
Tue Nov 2 08:51:06 MST 2004


I'm having problems getting a TDM11B (green FXS module in slot 1 and the 
red FXO card in slot 4) to configure at boot time. zaptool and ztcfg all 
indicate that the card is working fine and with no errors, but the log 
file has the following messages:

    Nov  1 14:14:54 asterisk kernel: Zapata Telephony Interface Registered on major 196
    Nov  1 14:14:54 asterisk kernel: Specify address with base=0xNNNNN
    Nov  1 14:14:54 asterisk kernel: Registered Tormenta2 PCI
    Nov  1 14:14:54 asterisk kernel: PCI: Enabling device 01:03.0 (0004 -> 0007)
    Nov  1 14:14:54 asterisk kernel: Freshmaker version: 71
    Nov  1 14:14:54 asterisk kernel: Freshmaker passed register test
    Nov  1 14:14:54 asterisk kernel: Timeout waiting for calibration of module 0
    Nov  1 14:14:54 asterisk kernel: Timeout waiting for calibration of module 0
    Nov  1 14:14:54 asterisk kernel: Proslic Failed on Second Attempt to Auto Calibr
    Nov  1 14:14:54 asterisk kernel: Module 0: Installed -- MANUAL FXS
    Nov  1 14:14:54 asterisk kernel: Module 1: Not installed
    Nov  1 14:14:54 asterisk kernel: Module 2: Not installed
    Nov  1 14:14:54 asterisk kernel: Module 3: Installed -- AUTO FXO (FCC mode)
    Nov  1 14:14:54 asterisk kernel: Found a Wildcard TDM: Wildcard TDM400P REV E/F (4 modules)
    Nov  1 14:14:54 asterisk kernel: usb.c: registered new driver wcusb
    Nov  1 14:14:54 asterisk kernel: Wildcard USB FXS Interface driver registered
    Nov  1 14:14:54 asterisk kernel: Registered tone zone 0 (United States / North America)

The autoconfig of the FXS module isn't working and a spurious USB FXS 
interface driver gets registered for some reason (though zaptool doesn't 
show it).

While I can get a phone set to ring on the FXO port and the simple 
switch starts up when it goes off-hook, I don't get dial-tone and cannot 
dial out.

I've checked out the power cable it's using and it seems to be fine 
(11.97 v and 5.1v)

Anyone have any ideas on why it wouldn't auto configure, or how I can 
manually configure it?

Stephen






More information about the asterisk-users mailing list