[Asterisk-Users] R2 support

[Steve Underwood]

Hi,

I make it compile. I just never finished it. :-)

What I did to make R2 work properly was throw away the code that is now 
in CVS at Digium, and write a new implementation from scratch. I guess 
that is not quite the answer you wanted to hear. :-(

Regards,
Steve


Jorge Verastegui wrote:

>Hi
> I know there is no support for R2, but I succcessfully compiled and ran
>the libr2.  However, I am not able to initiate calls.  
>
>The error I get is
>
>Couldn't call g3/71605538
>    -- Hungup 'Zap/32-1'
>  == Everyone is busy at this time
>
>I understand that the idle signaling is not working right, any ideas on
>what I can do to fix this problem?
>
>Looking forward to your responses.
>
>Regards,
>
>Jorge
>
>
>On Fri, 2004-04-30 at 22:58, Steve Underwood wrote:
>  
>
>>jorge verastegui wrote:
>>
>>    
>>
>>>Hi
>>>
>>>i have successfully downloaded and compiled libr2 from source.
>>>
>>>But i dont seem to find how to properly configure it. When i run it
>>>(partcially unconfigured) the following error occurrs
>>>
>>>Signalling requested is R2 Signalling but line is in PRI Signalling
>>>signalling
>>> 
>>>
>>>      
>>>
>>This error is easy to fix by changing ccs to cas, and removing crc4, in 
>>your zaptel.conf file. However libr2 does not work. It is a partly 
>>implemented solution which I abandoned. It only gets you about 10% of 
>>the way to a working R2 system :-(
>>
>>My current R2 software is completely different.
>>
>>Regards,
>>Steve
>>    
>>
]