[Asterisk-Users] Incoming calls.

[Stephen J. Wilcox]

Hi Mark,
 its sets the context in zapata.conf.. put a context=<contextname> somewhere 
above where you define the channels

then in your extensions.conf, create the context if you've not already, start 
with a exten=> _.,1,Dial(blah...) then modify from that to suit your setup

Steve

On Mon, 1 Mar 2004, Mark Messmore, Technical Support, University Telcom...:

> 
> Hey...I'm sure that this is something very simple that I'm missing (I've
> had * just about 2 weeks or so now and just finally got my x100p card
> in).  Here's my simple setup.
> 
> VoIP Network--*--PSTN via X100P
> 
> I can make outbound calls from my VoIP network just fine.  However, when
> trying to dial in I receive the following messages in my console.
> 
> 
> -- Starting simple switch on 'Zap/1-1'
> Mar  1 15:58:30 WARNING[1234379840]: pbx.c:1778 ast_pbx_run: Channel
> 'Zap/1-1' sent into invalid extension 's' in context 'default', but no
> invalid handler
>     -- Hungup 'Zap/1-1'
> 
> I've looked all through my extensions.conf and my sip.conf (I figured
> that was not the place, but thought that I would look anyway)...however
> I can not find where this is receiving the context as "default" and the
> extension as "s".  I realize that these are the defaults with the
> configs from my install...In what other configuration files should I be
> looking so I can set this to where it really should go?
> 
> Thanks in advance!
> 
> Mark 
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>