[Asterisk-Users] RE: current version

[Brian West]

You can't use chan_h323 with call manager.

bkw

On Sun, 18 Jan 2004, Dan Austin wrote:

> I tried to use it to create a 'trunk' to Cisco's call manager.  The
> 0.7.1 code worked up to a point.
>
> The call would be established, but audio was one-way from the Call
> Manager.  Asterisk with
>
> Chan_h323 would not setup the sending rtp stream.  The debug results
> showed the sending
>
> stream as using ip:0.0.0.0
>
>
>
> I have not checked for a CVS update to see if it is fixed, or if that
> might just be a quirk when
>
> connected to Call Manager.  Chan_oh323 works fine with Call Manager.
>
>
>
> Dan
>
>
>
>   _____
>
> From: T. Chan [mailto:tommy.chan at utimail.com]
> Sent: Sunday, January 18, 2004 5:55 PM
> To: asterisk-users at lists.digium.com
> Cc: Alan Chan
> Subject: [Asterisk-Users] RE: current version
>
>
>
> Dear All,
>
>
>
> I have been using Asterisk "10 days ago" version loaded onto my Redhat
> 7.3 with kernel 2.4.18-3 running Jeremy's h323 driver. It has been
> running okay with a bit of problems, like system crashing after certain
> period of time with 15 simultaneous calls or so.
>
>
>
> I have tried to load up the current version today again (0.7.1 I guess)
> and apparently with the new H323 driver as well. I have recompiled the
> H323 libraries with version Pwlib1.5.2 and Openh3231.12.2 as
> recommended. However, no call was able to get through at all. I have
> tried this before when 0.7.0 came out when had the same result, I
> thought there were bugs, but now I am getting the same thing. I have
> tried using the same h323.conf configuration as well as trying to change
> a couple of faststart.....parameters, but same result.
>
>
>
> Is there anyone who has had good experience with the new version of
> Asterisk 0.7.1 with the most current Jeremy H323 driver?
>
>
>
> Please suggest, thanks
>
>
>
> Tom
>
>