[Asterisk-Users] "New" TDM cards--driver won't load

[Tjardick van der Kraan]

Same problem here but

cat /proc/pci showed me a different IO address then the standard one so i
replaced it in the make file and off i went :)

greetings,

Tjardick


----- Original Message ----- 
From: "Stuart Mackintosh" <sm at opusvl.com>
To: <asterisk-users at lists.digium.com>
Sent: Monday, October 13, 2003 1:25 PM
Subject: Re: [Asterisk-Users] "New" TDM cards--driver won't load


> Hi all, FYI,
>
> I had a similar problem where the new TDM card would show up in
> /proc/pci but would not load the module.
>
> Checked out the latest CVS zaptel, made / installed and loaded straight
> away. Used Gigabyte GA-8S648 board.
>
> Stuart.
>
>
> On Fri, 2003-10-03 at 19:49, Mark Spencer wrote:
> > > > Is it showing up on /proc/pci?  It should be a tigerjet.
> > >
> > > Yes.  I put the other card back in (production machine) but over the
> > > weekend I'll get the card in there and capture the output of lspci.
> >
> > If the card shows up in /proc/pci then your motherboard *must* be
> > supplying 3.3V somehow (unless it's just leaking back somehow, but that
> > doesn't seem very likely).
> >
> > > Nope.  Doesn't show any sign of seeing the card at all.  It does see
the
> > > FXO card that's in the same machine.
> >
> > We should check the PCI ID's.  There may be a difference in what we're
> > looking for and what is there.
> >
> > Mark
> >
> > _______________________________________________
> > Asterisk-Users mailing list
> > Asterisk-Users at lists.digium.com
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> -- 
>
>  | http://www.opusvl.com
>  | T: 08717 50 40 02
>  | F: 08717 50 40 03
>  | E: sm at opusvl.com
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>