[Asterisk-Users] PCI Master abort (debian / S400P & X101P

[Martin Pycko]

You have one board on the same IRQ as VGA. Try to replace the board in a
diffrent PCI slot or maybe you can do the IRQ job in the BIOS.

Martin

On Fri, 4 Jul 2003 frank.barthe at prescom.net wrote:

> Debian / kernel 2.4.18.
> Found in /proc/pci ::
>     Bus  0, device   0, function  0:    Host bridge: Intel Corp. 430HX -
> 82439HX TXC [Triton II] (rev 3).
>     Bus  0, device   7, function  0:    ISA bridge: Intel Corp. 82371SB PIIX3
> ISA [Natoma/Triton II] (rev 1).
>     Bus  0, device   7, function  1:    IDE interface: Intel Corp. 82371SB
> PIIX3 IDE [Natoma/Triton II] (rev 0).
>     Bus  0, device   9, function  0:    VGA compatible controller: IRQ 10.
>     Bus  0, device  10, function  0:    Tiger Jet Network Inc. Model 300 128k
> (rev 0). IRQ 12.
>     Bus  0, device  12, function  0:    Tiger Jet Network Inc. Model 300 128k
> (#2) (rev 0). IRQ 9.
>     Bus  0, device  11, function  0:    Realtek Semiconductor Co., Ltd.
> RTL-8029(AS) (rev 0). IRQ 11.
>
> Commands sent :
>     => modprobe zaptel
>     => modprob wcfxs
>     => modprobe wcfxo
>
> No pb !
>
> THEN :
>
>     wait about 2 minutes (no more command passed)
>     => PCI Master abort
>
> OR
>
>     => asterisk -cvvv
>     => (zt_open): Unable to specify channel 1
>     => PCI Master abort
> _______________________________________________________________________________
>
> Does any body work with the same HW configuration (1 FXO + 1 FXS) ?
> (Wildcard S400P 4 modules / 1 installed   +   Wildcard X101P)
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>