[Asterisk-Users] '#' doesn't work for me

[Dan]

Hi Brian,

ATA is in SIP mode, and RFC2833 is used.
Something else to check?

Thanks,
Dan


----- Original Message ----- 
From: "Brian West" <brian at bkw.org>
To: <asterisk-users at lists.digium.com>
Sent: Thursday, August 14, 2003 6:16 PM
Subject: Re: [Asterisk-Users] '#' doesn't work for me


> Accually it will work with any codec if you use rfc2833.  G711 is only
> needed if you are passing DTMF inband.
>
> bkw
>
> On Thu, 14 Aug 2003, Martin Pycko wrote:
>
> > It works only with G711 (ulaw/alaw)
> >
> > regards
> > Martin
> >
> > On Thu, 14 Aug 2003, Dan wrote:
> >
> > > Hi,
> > >
> > > I cannot use '#' to initiate transfers.
> > > I have tried on different phones (7960, ATA, X-Lite).
> > > When I press '#' during a call, nothing happen.
> > > I have both T and t switches in Dial application.
> > > The transfer function works with Flash key on ATA, but in a very
strange
> > > way....The final destination is hunged up and then automatically
called by
> > > the initial caller... This behavior request to put on hook the phone
> > > connected to the ATA in order to accept the transfer. During this
period the
> > > phone is busy for the caller, so I must use some tricks in the dialing
macro
> > > in order to acomodate this.
> > >
> > > Any other suggestions to better solve the transfer function?
> > >
> > >
> > > BR,
> > > Dan
> > >
> > > _______________________________________________
> > > Asterisk-Users mailing list
> > > Asterisk-Users at lists.digium.com
> > > http://lists.digium.com/mailman/listinfo/asterisk-users
> > >
> >
> > _______________________________________________
> > Asterisk-Users mailing list
> > Asterisk-Users at lists.digium.com
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> >
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>
>