[Asterisk-Users] Seting up TDM40B

[Martin Pycko]

It can be a bad module. Contact shipping at digium.com.

regards
Martin

On Wed, 6 Aug 2003, Eduardo Goncalves wrote:

> Martin,
>
> 	With KFLAGS+=-DNO_CALIBRATION uncommented, the module loads fine. Without the calibration.
> 	But I have no dial-tone on port 4. All the three other ports works fine.
> 	Could it be a hardware problem?
>
> Thanks in Advance
> Eduardo
>
> On Fri, 1 Aug 2003 16:11:12 -0500 (CDT)
> Martin Pycko <martinp at digium.com> wrote:
>
> > Try to uncomment in zaptel/Makefile
> > KFLAGS+=-DNO_CALIBRATION
> >
> > and "make clean install"
> >
> > that should help
> >
> > Martin
> >
> > On Fri, 1 Aug 2003, Eduardo Goncalves wrote:
> >
> > > On Fri, 1 Aug 2003 15:34:23 -0500 (CDT)
> > > Martin Pycko <martinp at digium.com> wrote:
> > >
> > > > What does 'dmesg' say ?
> > > >
> > >
> > >
> > > CSLIP: code copyright 1989 Regents of the University of California
> > > PPP generic driver version 2.4.1
> > > Zapata Telephony Interface Registered on major 196
> > > Freshmaker version: 62
> > > Freshmaker passed register test
> > > Module 0: Initialized
> > > Module 1: Initialized
> > > Module 2: Initialized
> > > Timeout waiting for calibration of module 3
> > > ProSlic died on Calibration.
> > > Module 3: Not installed
> > > Found a Wildcard FXS: Wildcard S400P Prototype (4 modules)
> > >
> > > 	and then the errors that I mentioned.
> > >
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>