[Asterisk-Users] Behind Firewalls, SonicWalls, etc..

[WipeOut .]

Your best bet is probably the Sonicwall cos IIRC they don't use NAT but rather a packet forwarding bridge which means that you will be able to assign the * box a pulic IP address and then open the ports required..

> 
> I've searched the archives a bit and have not really come up with
> a good answer to my queries.
> 
> I have * running on a RH9 box behind a LinkSys NAT box.  I can talk
> with iConnectHere outbound just fine.  I am trying to configure an
> inbound Xten softphone from outside.  I have that user set as NAT in
> sip.conf (seems to help), but I still cannot establish a full session.
> I think the problem comes when * sends info about the RTP connection,
> it passes the nonroutable address.  Is there a ways to tell it to use
> the firewall IP address for users coming in through that address(and the
> firewalls nonroutable address).
> 
> On the flip side, I have run out of port forwarding slots on my LinkSys,
> so I am trying to resurrect my old startup's SonicWall PRO.  They indicate
> they support SIP, but they do not elaborate upon that at all.  Anyone have
> comments concerning the SW & SIP?
> 
> So far I have an ATA-186, a DG104S, as well as a TDM400P and X100P with
> service from iConnectHere.  I hope to ship either the ATA-186 or DG104S
> to Australia when I figure out how to deal with them remotely.
> 
> Thanks,
> 
> -- John
> 
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users

-- 
______________________________________________
http://www.linuxmail.org/
Now with e-mail forwarding for only US$5.95/yr

Powered by Outblaze