<p><br>
On Jan 10, 2011 9:59 AM, "Wasim Baig" <<a href="mailto:wasim@convergence.pk">wasim@convergence.pk</a>> wrote:<br>
><br>
> On Sun, Jan 9, 2011 at 23:18, Benaiad <<a href="mailto:benaiad@gmail.com">benaiad@gmail.com</a>> wrote:<br>
>><br>
>> Hi,<br>
>><br>
>> ;First of all, I'm newbie in this field, so please forgive my unprofessional explanation.<br>
>><br>
>><br>
>> I'm trying to connect to a mobile operator with chan_ss7 using sangoma card.<br>
>> the telecom regulator initiated an SPC code for us<br>
>> Now, the operator's engineer asked me for the following parameters:<br>
>> OPC , Link type , TS , SLC.<br>
><br>
><br>
> Ideally, they should give a Point Code for you as well, if they don't, you can choose any<br>
> arbitrary figure like "1234" or "1" or "69".</p>
<p>But where do i configure the SPC then?</p>
<p>> <br>
>><br>
>> but I don't know what should I provide to him.<br>
>> I think the OPC similar to our SPC, And the Link type is 64k, <br>
>> But for TS and SLC, I don't know what to say.<br>
><br>
><br>
> TS is the timeslot/chan on which you will send signalling. On each E1 you have 31 TS.<br>
> Normally 16 is used, although you can use any 1 to 31.<br>
><br>
> Use SLC=0 for the first link.<br>
> </p>
<p>Thanks a lot, shokran, merci, gratci.</p>
<p>Regards,<br>
--<br>
Benaiad</p>
<p>><br>
><br>
><br>
><br>
> -- <br>
> wasim h. baig | principal consultant | convergence pk | +92 30 0850 8070 | peace be upon you<br>
</p>