[asterisk-ss7] [HELP]:Suggestions needed in choosing proper channel Type in zaptel.conf for SS7 network

[Marcelo Pacheco]

The easiest way to do this is to use libss7 + dahdi's native ss7
support, unless you want to look at all those repeated FISUs and LSSUs.
Also this way you don't need to perform HDLC decoding, each MTP2 message
comes as a single read/recv.

Satish Chandra wrote:
> Hi All,
>
> I am trying to develop a Tapping device that can be used in a SS7
> network. I am not able decide on a particular channel type which I
> should configure in zaptel.conf. The device needs to sit on a SS7
> (T1/E1) link. As I will be duplicating signal using a tapping
> (Y-shaped) wire, I need not to send any signal from the device. So, in
> a way the device will just receive signals and will not transmit any.
>
> I read about mtp2 channel type in one of the article but was not able
> to find any documentation for its configuration in zaptel.conf
>
> I need suggestions whether I should use this channel type for this
> scenario or some other.
>
> Kinldy tell me how to configure.
>
> -- 
> Thanks Regards,
> Satish Chandra
> ------------------------------------------------------------------------
>
> _______________________________________________
> --Bandwidth and Colocation Provided by http://www.api-digital.com--
>
> asterisk-ss7 mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-ss7