[asterisk-ss7] Some Feature-Questions.
Peter Demeter
pdemeter at gmail.com
Wed Nov 29 01:17:35 MST 2006
Hi,
It seems that the remote switch thinks that you have CIC 33 whitin the
linkset, but your side configured differently. May I see your ss7.configfile?
Regards,
Peter
On 11/28/06, Marc Storck <mstorck at voipgate.com> wrote:
>
> When the remote switch (an ericsson switch, so this is a "real" link)
> sends messages to me for the CIC 33 and above, I see these messages:
>
> Nov 28 17:32:48 WARNING[658]: l4isup.c:4071 l4isup_event: Received
> CIC=33 for unequipped circuit (typ=GRS), link 'l1'.
>
> DO you have an advise for me?
>
> Best regards,
>
> Marc
>
> Goke Aruna wrote:
> > I tested that config on chan_ss7 and its working fine. I dont know of
> libss7
> >
> > goksie
> >
> > On 11/28/06, *Marc Storck* < mstorck at voipgate.com
> > <mailto:mstorck at voipgate.com>> wrote:
> >
> > In the mean time I tested this overhere, but with only two links (1
> > link
> > for each linkset), only the first link has an schannel.
> >
> > Using this config the channels on l2 stay in Idle Reset pending
> status,
> > trying to block and unblock channels has the following results:
> >
> > Nov 28 16:56:39 NOTICE[5667]: l4isup.c:3598
> > do_group_circuit_block_unblock: Sending CIRCUIT GROUP BLOCKING,
> cic=33,
> > mask=0x00000001.
> > Nov 28 16:56:39 WARNING[658]: mtp.c:1669 mtp_thread_main: No
> signalling
> > links inservice and no cluster receivers alive, dropping packet!
> >
> > Blocking and unblocking request from far end are ignored as no CICs
> are
> > assigned to linkset to which schannel from l1 is assigned.
> >
> > The ss7 driver however does not complain about the config itself,
> so
> > either the config error checking isn't checking this, or the driver
> > takes the binding of Schannel ==> linlkset to strictly....
> >
> > Who can tell???
> >
> > Thanks,
> >
> > Marc
> >
> > Goke Aruna wrote:
> > > yes... with chan_ss7.
> > >
> > > i have this sample and its working now.
> > >
> > > [linkset-xyz]
> > > enabled => yes
> > > enable_st => no
> > > use_connect => no
> > > hunting_policy => seq_lth
> > > subservice => auto
> > > language => en
> > > context => xyz-out
> > >
> > > [linkset-abc]
> > > enabled => yes
> > > enable_st => no
> > > use_connect => no
> > > hunting_policy => seq_lth
> > > subservice => auto
> > > language => en
> > > context => abc-out
> > >
> > > [link-l1]
> > > linkset => xyz
> > > channels => 1-15,17-31
> > > schannel => 16
> > > firstcic => 1
> > > echocancel=allways
> > > echocan_taps=32
> > > echocan_train=350
> > > enabled => yes
> > >
> > > [link-l2]
> > > linkset => xyz
> > > channels => 1-15,17-31
> > > schannel =>
> > > firstcic => 33
> > > echocancel=allways
> > > echocan_taps=32
> > > ;echocan_train=350
> > > enabled => yes
> > >
> > > [link-l3]
> > > linkset => abc
> > > channels => 1-15,17-31
> > > schannel =>
> > > firstcic => 65
> > > echocancel=allways
> > > echocan_taps=32
> > > ;echocan_train=350
> > > enabled => yes
> > >
> > > [link-l4]
> > > linkset => abc
> > > channels => 1-15,17-31
> > > schannel =>
> > > firstcic => 97
> > > echocancel=allways
> > > echocan_taps=32
> > > ;echocan_train=350
> > > enabled => yes
> > >
> > > [host-myhost]
> > > enabled => yes
> > > opc => 609
> > > default_linkset => xyz
> > > dpc => xyz:223,abc:223
> > > links => l1:1,l2:2,l3:3,l4:4
> > >
> > >
> > > i have this ss7.conf
> > >
> > > and its working for me.
> > >
> > > that is question number 1.
> > >
> > > i think question number 2 should not be a question since u said u
> > used
> > > the two box to test before.
> > >
> > > goksie
> > >
> > >
> > > asterisk at nicox.org <mailto:asterisk at nicox.org> wrote:
> > >> Is noone there who can answer my questions?
> > >>
> > >> :-(
> > >>
> > >>
> > >> On Wed, 22 Nov 2006, asterisk at nicox.org
> > <mailto:asterisk at nicox.org> wrote:
> > >>
> > >>> Hello,
> > >>>
> > >>> I have some feature-questions.
> > >>>
> > >>> 1.)
> > >>> I have one Asterisk Box with SS7 and 4 E1 Ports.
> > >>> i have one Telco with 4 Routings, a a high quality routing, a
> > quality
> > >>> Routing a cheap routing and a cheaper routing.
> > >>> The telco did not give me 4 SS7 Signalling Links.
> > >>> Is it Possible to get this running with chan_ss7 or libss7?
> > >>>
> > >>>
> > >>>
> > >>> 2.)
> > >>> I have 2 Asterisk boxes and one SS7-Signalling Link, is it
> > possible to
> > >>> make the signalling for the second box with the Signalling link
> > on the
> > >>> first Box?
> > >>>
> > >>>
> > >>>
> > >>> Thanks a lot for your help
> > >>>
> > >>>
> > >>> Nico
> > >>>
> > >>> _______________________________________________
> > >>> --Bandwidth and Colocation provided by Easynews.com
> > <http://Easynews.com> --
> > >>>
> > >>> asterisk-ss7 mailing list
> > >>> To UNSUBSCRIBE or update options visit:
> > >>> http://lists.digium.com/mailman/listinfo/asterisk-ss7
> > <http://lists.digium.com/mailman/listinfo/asterisk-ss7>
> > >>>
> > >> _______________________________________________
> > >> --Bandwidth and Colocation provided by Easynews.com
> > <http://Easynews.com> --
> > >>
> > >> asterisk-ss7 mailing list
> > >> To UNSUBSCRIBE or update options visit:
> > >> http://lists.digium.com/mailman/listinfo/asterisk-ss7
> > >>
> > >
> > > _______________________________________________
> > > --Bandwidth and Colocation provided by Easynews.com
> > <http://Easynews.com> --
> > >
> > > asterisk-ss7 mailing list
> > > To UNSUBSCRIBE or update options visit:
> > > http://lists.digium.com/mailman/listinfo/asterisk-ss7
> > _______________________________________________
> > --Bandwidth and Colocation provided by Easynews.com
> > <http://Easynews.com> --
> >
> > asterisk-ss7 mailing list
> > To UNSUBSCRIBE or update options visit:
> > http://lists.digium.com/mailman/listinfo/asterisk-ss7
> >
> >
> >
> > ------------------------------------------------------------------------
> >
> > _______________________________________________
> > --Bandwidth and Colocation provided by Easynews.com --
> >
> > asterisk-ss7 mailing list
> > To UNSUBSCRIBE or update options visit:
> > http://lists.digium.com/mailman/listinfo/asterisk-ss7
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-ss7 mailing list
> To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-ss7
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-ss7/attachments/20061129/b4f41d6c/attachment.htm
More information about the asterisk-ss7
mailing list