[asterisk-r2] asterisk R2 in Angola - Cannot create OpenR2 protocol context

[Carlos Rangel]

On digium boards you have to change the jumpers. They do not support changing E1 to T1 via software

 

Regards
CR 





Date: Wed, 24 Jun 2009 10:27:00 -0400
From: moises.silva at gmail.com
To: gomespereira at startel.pt; asterisk-r2 at lists.digium.com
Subject: Re: [asterisk-r2] asterisk R2 in Angola - Cannot create OpenR2 protocol context
e.


On Wed, Jun 24, 2009 at 6:51 AM, Gomespereira <gomespereira at startel.pt> wrote:




In the manual says:
"Remember that in the R2 world, the physical link is E1 not T1"

I did cat /proc/zaptel/1 and it shows:
Span 1: TE4/0/1 "T4XXP (PCI) Card 0 Span 1 (MASTER) HDB3 / ClockSource

Do I have an E1 or T1 configured board?
Thanks
Regards
Joao Pereira



If you see 31 channels then you have the card configured for E1 as it should be, otherwise T1 and you need to change the card jumper (I am not sure if Digium boards support changing from E1 to T1 from software as Sangoma boards do).

As of the guide,  you should use the official guide in the google code openr2 site (links are provided in http://www.libopenr2.org/)

-- 
Moises Silva
Software Developer
Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada
t. 1 905 474 1990 x 128 | e. moy at sangoma.com

_________________________________________________________________
Actualiza tu Perfil y gana!
http://www.actualizatuperfil.com.mx/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-r2/attachments/20090624/bd149929/attachment.htm