[asterisk-r2] MFCR2 With CrossOver Cable

[Fernando Berretta]

Hi,

I've installed Asterisk 1.4 and Openr2 1.1 all is working well. I've 
connected a crossover cable to TE122 board and board lite has went 
green. But when I've  tried to make a call, I've got the following trace:

[15:35:00:218] [Thread: 3078437776] [Chan 1] - Call started at Mon Apr  
6 15:35:00 2009 on chan 1
[15:35:00:218] [Thread: 3078437776] [Chan 1] - CAS Tx >> [SEIZE] 0x00
[15:35:00:218] [Thread: 3078437776] [Chan 1] - CAS Raw Tx >> 0x01
[15:35:00:242] [Thread: 3078437776] [Chan 1] - Bits changed from 0x08 to 
0x00
[15:35:00:242] [Thread: 3078437776] [Chan 1] - CAS Rx << [FORCED 
RELEASE] 0x00
[15:35:00:242] [Thread: 3078437776] [Chan 1] - Disconnection before 
seize ack detected![15:35:00:242] [Thread: 3078437776] [Chan 1] - Far 
end disconnected. Reason: Forced Release
[15:35:00:245] [Thread: 3078437776] [Chan 1] - Attempting to cancel 
timer timer 0
[15:35:00:245] [Thread: 3078437776] [Chan 1] - Cannot cancel timer 0
[15:35:00:245] [Thread: 3078437776] [Chan 1] - CAS Tx >> [CLEAR FORWARD] 
0x08
[15:35:00:245] [Thread: 3078437776] [Chan 1] - CAS Raw Tx >> 0x09
[15:35:00:306] [Thread: 3081632656] [Chan 1] - Bits changed from 0x00 to 
0x08
[15:35:00:306] [Thread: 3081632656] [Chan 1] - CAS Rx << [IDLE] 0x08
[15:35:00:306] [Thread: 3081632656] [Chan 1] - Call ended
[15:35:00:306] [Thread: 3081632656] [Chan 1] - Attempting to cancel 
timer timer 0
[15:35:00:306] [Thread: 3081632656] [Chan 1] - Cannot cancel timer 0

Is there some way to complete a call through crossover cable with R2 ? 
How should I configure dahdi ?

Best Regards,
Fernando