[asterisk-gui] Problems with Analog Line

[bkruse]

Get the latest version of the gui from reading this:

http://asteriskNOW.org/install-related

Then make and make install that.

You will now have zapscan, run through the setup wizard once again, and 
it should detect the card.

(assuming its a zaptel card and linked in with zaptel (/dev/zap/ctl))

-bk

Gustavo Fukao wrote:
> I'm  trying to use the GUI to add and set analog line but I got error...
>
> Lines: No analog line hardware installed on the system
>
>
> but
> -------------------------------------------------------------------------------------------
> bsd# ztcfg -vv
> Keyword: [fxsks], Value: [1]
> Keyword: [loadzone], Value: [us]
> Keyword: [defaultzone], Value: [us]
>
> Zaptel Version: 1.4.0-BSD
> Echo Canceller: MG2
> Configuration
> ======================
>
>
> Channel map:
>
> Channel 01: FXS Kewlstart (Default) (Slaves: 01)
>
> 1 channels configured.
>
> -------------------------------------------------------------------------------------------
>
>
>
> and on asterisk
>
> -------------------------------------------------------------------------------------------
> bsd*CLI> zap show status
> Description                              Alarms     IRQ        bpviol
>    CRC4
> Wildcard X100P Board 1                   RED        0          0
>    0
>
>
> -------------------------------------------------------------------------------------------
> bsd*CLI> zap show channels
>    Chan Extension  Context         Language   MOH Interpret
>  pseudo            receive         en         default
>       1            receive         en         default
>
> -------------------------------------------------------------------------------------------
>
>
> What can I do to fix ???
>
>
>
>
> Thanks
>
>
>