[asterisk-dev] RFC: pjsip show endpoints output format

[Joshua Colp]

Rod Dorman wrote:
> On Thursday, November 7, 2013, 10:23:31, Joshua Colp wrote:
>> George Joseph wrote:
>>> Comments please...
>>>
>>> I tried to balance readability, usefullness, and the fact that the
>>> output is a flat representation of a relational model.
>>>
>>> Here's a pastebin if you can't read the output below.
>>> http://pastebin.com/JiPKLY3A
> ?
>> My worry about this is that we're giving *too much* information in one
>> command and overloading the person looking at it. Given a large number
>> of endpoints it's now potentially using, well, a lot of lines per
>> endpoint. I think a simplified command that simply gives a list of the
>> endpoints would be nice (in addition to this), and then if more granular
>> info is required by the user they can get the specific endpoint.
>>
>> Thoughts?
>
> What about a 'verbose' or 'full' keyword to trigger the "lot of lines"
> mode?

I'd be down with that.

-- 
Joshua Colp
Digium, Inc. | Senior Software Developer
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at:  www.digium.com  & www.asterisk.org