[asterisk-dev] How we can use BV Codec in Asterisk?

[Nick Lewis]

>I really don't see how that could be.  Each codec translation has a
non-zero
>impact on each CPU, which if you made it as your internal format would
mean
>that you would impose a rather large impact on the potential number of
calls
>that each machine could process.  Signed linear or signed linear 16kHz
is
>probably the best format you could use, as most translations use that
as an
>intermediate format anyway.

Depends on curex cost of bandwidth versus capex cost of cpu mips. If the
asterisk boxes are on two sites connected by leased lines then the
bandwidth 
can be expensive and it may worth the mips to compress the audio?

_____________________________________________________________________
This message has been checked for all known viruses by Star Internet delivered through the MessageLabs Virus Control Centre.
_____________________________________________________________________
Disclaimer of Liability
ATL Telecom Ltd shall not be held liable for any improper or incorrect use of the  information described and/or contained herein and assumes no responsibility for anyones use  of the information. In no event shall ATL Telecom Ltd be liable for any direct, indirect,  incidental, special, exemplary, or consequential damages (including, but not limited to,  procurement or substitute goods or services; loss of use, data, or profits; or business  interruption) however caused and on any theory of liability, whether in contract, strict  liability, or tort (including negligence or otherwise) arising in any way out of the use of  this system, even if advised of the possibility of such damage.

Registered Office: ATL Telecom Ltd, Fountain Lane, St. Mellons Cardiff, CF3 0FB
Registered in Wales Number 4335781

All goods and services supplied by ATL Telecom Ltd are supplied subject to ATL Telecom Ltd standard terms and conditions, available upon request.