[asterisk-dev] I Can't acces PSTN numbers

[Christian B]

looks like ser is not accepting the call or similar, checkout the
'ngrep' command and listen for incoming packets on the ser-port
respectively ip/machine:

ngrep -W byline port 5060 or ngrep -W byline host xxx.xxx.xxx.xxx

if you can't find the problem with this debug, you should go to the
users-list to ask your question(this list is intended for the
development of asterisk, not its configuration)

regards
christian


On Sat, 27 May 2006 11:44:12 -0300
"Sebastian Milioto" <smilioto at gmail.com> wrote:

> Hi all,
> 
> I hava SER with many clients (sipura SPA2100). One of these is an
> Asterisk which have others clients (sipuraSPA2100).
> I also have a Cisco GW which give me access to the PSTN.
> I make calls to all IP phones in my network, but I can't call PSTN
> numbers. After I dial, I hear 2 ringbacks but at the same time
> Asterisk says:
> 
> Called pstn_number at SER_ip_address
> SIP/SER_ip_address-ec75 is circuit-busy
> Everyone is  busy/congested at this time (1:0/1/0)
> 
> Then I hear busy tone.
> 
> I tried thousands of parameters. (Ovbiously not the correct one :-s )
> Any body could help me with this?
> 
> Thanks very much in  advance
> 
> Sebastian
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> asterisk-dev mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-dev