[Asterisk-Dev] ringback after PlayBack()

[Guo-Wei Chiuan]

Hm...I do not answer the line.
I think the channel is still in RING state but UP state, since I use
Playback(...,noanswer).

My goal is to indicate RINGING upon a caller channel in RING state by using
"180 Ringing" after 183 is ent.
However, according to source codes, after 183 is sent(in my case, due to
Playback() is done), Asterisk would not send "180 Ringing". That is what I
am trying to figure out.....

Maybe I shall look up RFC3960. Any ideas?


thanks
-Jerry

On 1/19/06, Eric ManxPower Wieling <eric at fnords.org> wrote:
>
> Once you ANSWER the line, you need /etc/asterisk/indications.conf since
> then you need to transmit inband ringing.  At least I did on my systems.
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-dev/attachments/20060118/ed0e8d5a/attachment.htm