[asterisk-dev] Problem with two cards Digium

[Bartosz Supczinski]

Hello,

I`ve got a problem which I can`t deal with. I own 2 cards - TDM2400P and 
TE410P. I`ve put them into a HP Proliant DL380 G4 server, compiled the 
drivers according to the manual. Unfortunetly there are both cards 
channels are configured in zaptel.conf file the first module (in this 
file) sends an error.

For configuration:

span = 1, 1, 0, ccs, hdb3, crc4
fxsks = 21-24
bchan = 25-39, 41-55
dchan = 40

root# modprobe zaptel
root# modprobe wctdm24xxp
------------------------------
ZT_CHANCONFIG failed on channel 25: No such device or address (6) FATAL: 
Error running install command for wctdm24xxp

For configuration:

span = 1, 1, 0, ccs, hdb3, crc4
bchan = 1-15, 17-31
dchan = 16
fxsks = 145-148

root# modprobe zaptel
root# modprobe wct4xxp
----------------------
ZT_CHANCONFIG failed on channel 145: No such device or address (6) 
FATAL: Error running install command for wct4xxp

If the configuration applies only a single card the modules are loaded 
correctly. The analog card is equiped with one FXO module, which is 
placed in the last joint. I`ve disabled hyperthreading in my kernel and 
in BIOS, interrupts are not shared. Besides I`ve put the cards in other 
slots, switched on and off ACPI and other functions in BIOS as well as 
in my kernel. Maybe the problem is in the drivers?

I`ve attached some information which might be useful.
http://www.dir.pl/~supczinskib/logs.tgz

-- 
With best regards
Bartosz Supczinski
IT Manager


DIR
Konstytucji 3 Maja 2
86-300 Grudziadz
POLAND
www.dir.pl

t.: +48 (56) 6440100
f.: +48 (56) 6440111
m.: +48 (504) 019040