[Asterisk-Dev] G729 Question

[Tom Dickenson]

Yep Cisco ATA had to RX TX and LBR had to be set to 3 

----- Original Message ----- 
From: "Brian West" <brian.west at mac.com>
To: "Asterisk Developers Mailing List" <asterisk-dev at lists.digium.com>
Sent: Thursday, April 07, 2005 12:38 PM
Subject: Re: [Asterisk-Dev] G729 Question


> I think we already covered this in the dev conf didn't we?
> 
> /b
> 
> On Apr 7, 2005, at 2:21 PM, Tom Dickenson wrote:
> 
> > SOMEONE WANT TO EXPLAIN THIS? While finally placing an outgoing call 
> > using
> > mutualphone (requiring that I get a G.729 License to do this) the 
> > following
> > pops up on asterisk's cli when a call is made (call works wondeful) 
> > just
> > curious to the extent of the following lines...
> >
> > Attempting native bridge on SIP/cisco1-5d0b and SIP/mutualphone-c59c
> >
> > Apr  7 12:01:58 WARNING[726]: rtp.c:1559 ast_rtp_bridge: codec0 = 12 
> > is not
> > codec1 = 256, cannot native bridge
> >
> > -Tom Dickenson
> >
> > _______________________________________________
> > Asterisk-Dev mailing list
> > Asterisk-Dev at lists.digium.com
> > http://lists.digium.com/mailman/listinfo/asterisk-dev
> > To UNSUBSCRIBE or update options visit:
> >    http://lists.digium.com/mailman/listinfo/asterisk-dev
> 
> _______________________________________________
> Asterisk-Dev mailing list
> Asterisk-Dev at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-dev
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-dev