[Asterisk-Dev] Raising loop current limit on the Proslic(reg.71)

[Paul Winkeler]

You beat me to it Matteo, I was about to ask that question myself.  Also, we
should then compute the load the card places on the power supply (+/- 12
volt specifically I suspect) so those of us with hand-me-down systems don't
end up chasing a whole new set of problems, LOL!

 PaulW

(216) 533-5708


> -----Original Message-----
> From: asterisk-dev-admin at lists.digium.com 
> [mailto:asterisk-dev-admin at lists.digium.com] On Behalf Of 
> Brancaleoni Matteo
> Sent: Friday, March 05, 2004 5:15 PM
> To: asterisk-dev at lists.digium.com
> Subject: Re: [Asterisk-Dev] Raising loop current limit on the 
> Proslic(reg.71)
> 
> 
> Hi
> > 
> > Yikes.  I was not aware of this.  Thanks for the note though, along 
> > with
> > Matteo's fixes for "heavier" loads for the TDM400P I think 
> the archives are 
> > much better off for it all.  :-)
> 
> the patch is very simple, I'm preparing it.
> but before that, I really like that someone from 
> Digium tell us that there's no problem
> for the tdm module to raise the max loop current limit...
> 
> Matteo
> 
> -- 
> Brancaleoni Matteo <mbrancaleoni at espia.it>
> Espia - Emmegi Srl
> 
> _______________________________________________
> Asterisk-Dev mailing list
> Asterisk-Dev at lists.digium.com 
> http://lists.digium.com/mailman/listinfo/aster> isk-dev
> To 
> UNSUBSCRIBE or update options visit:
>    
http://lists.digium.com/mailman/listinfo/asterisk-dev