[asterisk-bugs] [JIRA] (ASTERISK-14937) v23 caller id detection (UK) less than 100%

[Matt Jordan (JIRA)]

    [ https://issues.asterisk.org/jira/browse/ASTERISK-14937?page=com.atlassian.jira.plugin.system.issuetabpanels:comment-tabpanel&focusedCommentId=225123#comment-225123 ] 

Matt Jordan commented on ASTERISK-14937:
----------------------------------------

Since there's a good chance that [~rmeyerriecks] solved this issue, I'm going to close this out as "most likely fixed" :-)

Either way, it would be good for someone to reproduce this issue on a supported version of Asterisk that is past the versions fixed in ASTERISK-23488, namely 11.9.0 and any 13.x release.

> v23 caller id detection (UK) less than 100%
> -------------------------------------------
>
>                 Key: ASTERISK-14937
>                 URL: https://issues.asterisk.org/jira/browse/ASTERISK-14937
>             Project: Asterisk
>          Issue Type: Bug
>          Components: Channels/chan_dahdi
>            Reporter: trouble dog
>            Severity: Minor
>         Attachments: clid66.out
>
>
> Around 1 in 100 will fail with callerid.c: No start bit found in fsk data
> After implementation of polarity detection in wcfxo.c I initially believed there was an issue with my implementation or the hardware (X100P SE). I setup enhanced logging and data capture and discovered that this was not the case. There is a certain amount of noise present most of which could be removed with a band pass filter, which I believe should help detection rates. I do not believe the noise is inherent in the line, most of the noise can be characterised as low frequency noise (mentioned in si3034 spec as dc offset) and 4khz squeal. I have the raw data captured directly from wcfxo if there is any interest in improving this. 
> ****** ADDITIONAL INFORMATION ******
> Steps to reproduce
> Repeatedly dialing my PSTN line via sip trunk e.g.
> RetryDial(|15|-1|...|15|d)



--
This message was sent by Atlassian JIRA
(v6.2#6252)