[asterisk-bugs] [LibPRI 0015797]: RR storm on libpri 1.4.10.1

[Asterisk Bug Tracker]

The following issue requires your FEEDBACK. 
====================================================================== 
https://issues.asterisk.org/view.php?id=15797 
====================================================================== 
Reported By:                tzafrir
Assigned To:                
====================================================================== 
Project:                    LibPRI
Issue ID:                   15797
Category:                   General
Reproducibility:            always
Severity:                   major
Priority:                   normal
Status:                     feedback
Asterisk Version:           1.4.26.1 
JIRA:                        
SVN Branch (only for SVN checkouts, not tarball releases):  1.4  
SVN Revision (number only!):  
Disclaimer on File?:        N/A 
Request Review:              
====================================================================== 
Date Submitted:             2009-08-31 03:52 CDT
Last Modified:              2010-05-28 04:17 CDT
====================================================================== 
Summary:                    RR storm on libpri 1.4.10.1
Description: 
The following was tested on libpri 1.4.10.1 .

Symptom: after a while RR-s are sent frequently. More frequently than once
per 10 seconds. This is most common on BRI where providers tend to
occasionally take the connection down. But can also be reproduced by
disconnecting the line, reconnecting and allowing libpri to recover.

Note that the issue may not easily reproduce on a local [bp]ri loopback
setup, probably due to timing considerations. The problem is also
reproduced with two Asterisk servers connected through PRI.

Timer t203 is automatically scheduled at end of __q921_receive() function.
Therefore it is scheduled for example after receiving DISC, UA etc. Those
timer events are not removed and automatically rescheduled again and again
that causes eventually RR exchange each seconds instead of each 10 seconds.
Ref the attached log.

The problem was introduced in libpri 1.4 r680 (a while after 1.4.9 was
released) after call to "q921_reset(pri)" was removed from the beginning of
the "q921_dchannel_up()" function.

The problem is that the old T203 timer was never reset. Once the
connection is up, triggering it will still yield sending an RR. After a
second disconnect/reconnect we will have three timers trigerring sending
RRs, and so forth.
====================================================================== 

---------------------------------------------------------------------- 
 (0122598) russell (administrator) - 2010-05-28 04:17
 https://issues.asterisk.org/view.php?id=15797#c122598 
---------------------------------------------------------------------- 
There have been many improvements in LibPRI 1.4.11, could you verify if
this is still a problem for you? 

Issue History 
Date Modified    Username       Field                    Change               
====================================================================== 
2010-05-28 04:17 russell        Note Added: 0122598                          
2010-05-28 04:17 russell        Assigned To              mattf =>            
2010-05-28 04:17 russell        Status                   assigned => feedback
======================================================================