[asterisk-bugs] [Zaptel 0011346]: VPM450: Failed to initialize

[noreply at bugs.digium.com]

The following issue has been RESOLVED. 
====================================================================== 
http://bugs.digium.com/view.php?id=11346 
====================================================================== 
Reported By:                ars888
Assigned To:                file
====================================================================== 
Project:                    Zaptel
Issue ID:                   11346
Category:                   wct4xxp
Reproducibility:            always
Severity:                   crash
Priority:                   normal
Status:                     resolved
Zaptel Version:              SVN 
SVN Branch (only for SVN checkouts, not tarball releases):  1.4  
SVN Revision (number only!): 3245 
Disclaimer on File?:        N/A 
Request Review:              
Resolution:                 suspended
Fixed in Version:           
====================================================================== 
Date Submitted:             11-22-2007 02:28 CST
Last Modified:              11-27-2007 08:21 CST
====================================================================== 
Summary:                    VPM450: Failed to initialize
Description: 
Hi there,

asterisk SVN-branch-1.4-r89462
zaptel SVN-branch-1.4-r3245
libpri 1.4.6

Trying to start TE407B (S/N BFF400728):

Zapata Telephony Interface Registered on major 196
Zaptel Version: SVN-branch-1.4-r3245
Zaptel Echo Canceller: MG2
Found TE4XXP at base address 90001000, remapped to f8a2c000
TE4XXP version c01a016a, burst OFF
Octasic optimized!
FALC version: 00000005, Board ID: 00
Reg 0: 0x30a61400
Reg 1: 0x30a61000
Reg 2: 0xffffffff
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a016a
Reg 7: 0x00001f00
Reg 8: 0x000200ff
Reg 9: 0x00f50000
Reg 10: 0x0000004a
TE4XXP: Launching card: 0
TE4XXP: Setting up global serial parameters
Found a Wildcard: Wildcard TE405P (3rd Gen)
About to enter spanconfig!
Done with spanconfig!
About to enter startup!
TE4XXP: Span 1 configured for CCS/HDB3
timing source auto card 0!
wct4xxp: Setting yellow alarm on span 1
timing source auto card 0!
SPAN 1: Primary Sync Source
timing source auto card 0!
VPM400: Not Present
VPM450: echo cancellation for 128 channels
Failed to open chip, code 001ff016!
VPM450: Failed to initialize
Completed startup!

No D-channels can be set-up with this set-up, though if we load like:

modprobe vpmsupport=0

Then everything works fine (no echocan obviously)
====================================================================== 

---------------------------------------------------------------------- 
 file - 11-27-07 08:21  
---------------------------------------------------------------------- 
Issues with Digium hardware products need to be taken up through Digium
technical support at the contact info given. They'll confirm there is an
issue and create an internal ticket. 

Issue History 
Date Modified   Username       Field                    Change               
====================================================================== 
11-27-07 08:21  file           Status                   assigned => resolved
11-27-07 08:21  file           Resolution               reopened => suspended
11-27-07 08:21  file           Note Added: 0074409                          
======================================================================