[asterisk-bugs] [Zaptel 0011346]: VPM450: Failed to initialize

[noreply at bugs.digium.com]

The following issue has been RESOLVED. 
====================================================================== 
http://bugs.digium.com/view.php?id=11346 
====================================================================== 
Reported By:                ars888
Assigned To:                file
====================================================================== 
Project:                    Zaptel
Issue ID:                   11346
Category:                   wct4xxp
Reproducibility:            always
Severity:                   crash
Priority:                   normal
Status:                     resolved
Zaptel Version:              SVN 
SVN Branch (only for SVN checkouts, not tarball releases):  1.4  
SVN Revision (number only!): 3245 
Disclaimer on File?:        N/A 
Request Review:              
Resolution:                 suspended
Fixed in Version:           
====================================================================== 
Date Submitted:             11-22-2007 02:28 CST
Last Modified:              11-26-2007 09:38 CST
====================================================================== 
Summary:                    VPM450: Failed to initialize
Description: 
Hi there,

asterisk SVN-branch-1.4-r89462
zaptel SVN-branch-1.4-r3245
libpri 1.4.6

Trying to start TE407B (S/N BFF400728):

Zapata Telephony Interface Registered on major 196
Zaptel Version: SVN-branch-1.4-r3245
Zaptel Echo Canceller: MG2
Found TE4XXP at base address 90001000, remapped to f8a2c000
TE4XXP version c01a016a, burst OFF
Octasic optimized!
FALC version: 00000005, Board ID: 00
Reg 0: 0x30a61400
Reg 1: 0x30a61000
Reg 2: 0xffffffff
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a016a
Reg 7: 0x00001f00
Reg 8: 0x000200ff
Reg 9: 0x00f50000
Reg 10: 0x0000004a
TE4XXP: Launching card: 0
TE4XXP: Setting up global serial parameters
Found a Wildcard: Wildcard TE405P (3rd Gen)
About to enter spanconfig!
Done with spanconfig!
About to enter startup!
TE4XXP: Span 1 configured for CCS/HDB3
timing source auto card 0!
wct4xxp: Setting yellow alarm on span 1
timing source auto card 0!
SPAN 1: Primary Sync Source
timing source auto card 0!
VPM400: Not Present
VPM450: echo cancellation for 128 channels
Failed to open chip, code 001ff016!
VPM450: Failed to initialize
Completed startup!

No D-channels can be set-up with this set-up, though if we load like:

modprobe vpmsupport=0

Then everything works fine (no echocan obviously)
====================================================================== 

---------------------------------------------------------------------- 
 file - 11-26-07 09:38  
---------------------------------------------------------------------- 
Please contact Digium Technical Support at support at digium.com or
877-546-8963. 

Issue History 
Date Modified   Username       Field                    Change               
====================================================================== 
11-26-07 09:38  file           Status                   new => resolved     
11-26-07 09:38  file           Resolution               open => suspended   
11-26-07 09:38  file           Assigned To               => file            
11-26-07 09:38  file           Note Added: 0074319                          
======================================================================