[Asterisk-bsd] Zaptel Drivers

[John S. Strock]

As a side note, how do I get zaptel.ko, I assume when I installed Asterisk
via the ports, it would've installed the *.ko file, but apparently not.

Thanks,

John
 

-----Original Message-----
From: asterisk-bsd-bounces at lists.digium.com
[mailto:asterisk-bsd-bounces at lists.digium.com] On Behalf Of Mimura,Shigeki
Sent: Tuesday, May 29, 2007 6:49 pm
To: Asterisk on BSD discussion
Subject: RE: [Asterisk-bsd] Zaptel Drivers


John Strock wrote:

> I'm running FreeBSD v6.2 and Asterisk v1.4.3.  I've installed Asterisk via
the Ports and everything has been working great.  I just ordered and
received a TDM01B card from Digium and am not sure how to install and
configure anything for it.  Ztcfg -vv give me the following:
> 
> ztcfg -vv
> 
> Notice: Configuration file is /usr/local/etc/zaptel.conf
> line 0: Unable to open master device '/dev/zap/ctl'
> Keyword: [fxsks], Value: [1,2,3,4]
> Keyword: [loadzone], Value: [us]
> Keyword: [defaultzone], Value: [us]
> 
> 1 error(s) detected
> 
> I've been using FreeBSD for several years, but am not familiar with
loading drivers or devices (I knew how to load devices in v4.11, but not
this version).
> 
> Can you direct me to any articles on configuring my card for FreeBSD?  Or
offer any help?

Did you load zaptel drivers?
You should add zaptel_enable="YES" to /etc/rc.conf, and then restart or
execute '/usr/local/etc/rc.d/zaptel start'.
_______________________________________________
Asterisk-BSD mailing list
Asterisk-BSD at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-bsd