[asterisk-announce] libpri 1.4.11.5 Now Available

[Asterisk Development Team]

The Asterisk Development Team has announced the release of libpri 1.4.11.5.
This release is available for immediate download at
http://downloads.asterisk.org/pub/telephony/libpri/

The release of libpri 1.4.11.5 resolves several issues reported by the
community and would not have been possible without your participation.
Thank you!

The following are some of the issues resolved in this release:

   * Prevent a CONNECT message from sending a CONNECT ACKNOWLEDGE in the
     wrong state.
     (issue #17360. Reported by: shawkris. Patched by rmudgett)

   * Made Q.921 delay events to Q.931 if the event could immediately
     generate response frames.
     (closes issue #17360. Reported by: shawkris. Patched by rmudgett)

   * BRI PTMP: Active channels not cleared when the interface goes down.
     (closes issue #17865. Reported by: wimpy. Patched by rmudgett)

   * Segfault in pri_schedule_del() - ctrl value is invalid.
     (closes issue #17522)
     (closes issue #18032. Reported by: schmoozecom. Patched by rmudgett)

   * Crash when receiving an unknown/unsupported message type.
     (closes issue #17968. Reported by: gelo. Patched by rmudgett)

   * B410P gets incoming call packets on ISDN but Asterisk doesn't see the
     call.
     (closes issue #18232. Reported by: lelio. Patched by rmudgett)

For a full list of changes in the current release, please see the
ChangeLog:

http://downloads.asterisk.org/pub/telephony/libpri/ChangeLog-1.4.11.5

Thank you for your continued support of Asterisk!